1. Unfolding the legs

Extend all four legs in sequence until fully locked in position.

2. Fixed bracket

Push bracket downwards to the locked-out position.

3. Adjustable Legs

On each leg, press button to unlock the lower leg. Slide the lower leg up and down to the desired height.

NOTE: Make Sure the extended button is engaged with a corresponding hole in the leg when the legs reach the required height.

4. Placement of hooks

Tilt the hook , first insert the “upper two positions” into the corresponding holes as shown in the figure, then insert the “lower two positions” into the corresponding positions and confirm locking.
Repeat the above to complete the hook on the other side.

NOTE: Ensure that all braces and legs are in the locked-out position and place the sawhorse into the upright position. Also ensure that all four feet are on a level surface when use.

5. Jobsite Table

Create a solid jobsite table with 2 sawhorses, Insert two 2x4s into the hooks , spanning the sawhorses.
Place a sheet of plywood across the 2x4s and ensure the plywood is fully supported on all sides.